steam parameter

Its results are showing: the ferritic-martensitic 9% to 12% Cr steels permit for the use of the units with steam parameter of 300bar 、 610 ℃/ 625 ℃. The thermal efficiency of these units will reach around 48%.

其结果表明：铁素体－马氏体9%～12%铬钢可以用于蒸汽参数为300bar、610℃/625℃的火电机组，其热效率可达到48%左右。

Steam trap load quantity is an important parameter that the users select steam trap.

蒸汽疏水阀负荷系数是用户选用疏水阀的一个重要参数。

Online thermodynamic parameter diagnosis of industry steam turbine is more of characteristics, and corresponding studies were taken recently, and many problems are pressing to be solved.

工业汽轮机热参数在线诊断更具有特点，研究才刚刚开始，有大量问题亟待研究解决。

Feed-forward compensation is the most commonly used control methods for the main steam pressure regulation, but it is too hard for the common fixed parameter control system to meet the needs of the control system.

对于主汽压力的调节，目前常采用是前馈补偿的控制方法，但普通的固定参数的控制系统很难满足控制要求。

Steam Flow Meter Model Selection THE CHOICE OF SMOOTH-SURFACE BLASTING PARAMETER

蒸汽流量表的选型光面爆破参数的选择

Rapid Calculation of Thermodynamic Parameter of Water and Steam

用计算机快速计算水和水蒸汽热力参数

Application of artificial neural network in on-line thermal parameter simulation and failure identification of steam turbine

人工神经网络在汽轮机热力参数在线仿真及故障识别中的应用

Double parameter measurement of steam water two phase flow by using differential pressure noise of orifice

利用孔板差压噪声测量汽水两相流

In this article, based on the large-scale off-design mathematic model, a thermal parameter fault diagnosis system is set up for nuclear power steam turbine.

利用核电汽轮机热力系统大范围变工况（全工况）数学模型建立核电热力系统故障诊断系统。

With the continuous improvement of steam turbo-generator capacity and main steam parameter, in order to guarantee the efficiency and security, the real-time and accuracy requirement of temperature measurement for the turbine rotor surface is improved at the same time.

随着现代汽轮机发电机组单机容量和主蒸汽参数的不断提高，为了确保机组效率和安全性，电厂对汽轮机转子表面温度检测的实时性和准确性要求也日益提高。